Cutting Knife (Eyelet Knife); Position Of The Cutting Knife - DURKOPP ADLER 580 Operating Instructions Manual

Single-chainstitch automat for stitched eyelets
Hide thumbs Also See for 580:
Table of Contents

Advertisement

10. Cutting knife (eyelet knife)

10.1 Position of the cutting knife

a)
b)
Caution: Danger of injury !
Turn off the main switch.
Adjust the cutting knife only with the machine switched off.
Standard checking
In case of automates for "cutting after sewing" the cutting knife 2
should cut exactly between the seam rows and in the center of the
eyelet (see illustration a).
In case of "cutting before sewing" the cutting knife should cut exactly
on the superimposed stitches and around the eyelet (see illustration b).
Attention: Danger of breakage !
Please take absolute care that the cutting knife corresponds to the
subclass and to the sewing equipment.
According to the sewing equipment the position of cutting knife 2 and
cutting block 1 (not in use on the photo) can be different.
Please take care in any case that the correct position of cutting knife
and cutting block is adjusted when the sewing equipment is changed
on the control panel.
The position of the cutting knife is indicated in the table on the next
page.
Furthermore, the matching clamping plates and fabric clamps must be
used for the new sewing equipment.
The machine must not be operated before the cutting block, the cutting
knife, the clamping plate and the fabric clamps have been adapted to
the new sewing equipment.
1
2
33
3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents