23.2 Adjusting the knife overlap
66
5
4
Caution: Danger of injury !
Adjust the trimmer for threads cut long only with the machine
switched off.
Standard checking
The blades 1 and 3 must move one on top of the other by 1 mm.
It must be possible to insert the clamping plate without jamming.
The roller 2 must reach in the groove of the linkage 5.
–
Remove the right clamping plate.
–
Reinsert the right clamping plate.
It must be possible to insert the clamping plate without jamming.
Correction
Adjusting the linkage
–
Loosen screw 4.
–
Shift the linkage 5 on the piston rod.
The dimension X should amount to 39 mm.
–
Tighten screw 4.
3
2
1