Adjusting The Knife Parallel To The Cutting Block - DURKOPP ADLER 580 Operating Instructions Manual

10.3 Adjusting the knife parallel to the cutting block

36
3 2 1
Caution: Danger of injury !
Turn off the main switch.
Adjust the knife only with the machine switched off.
–
Loosen screws 1, 2 and 3.
–
Put the key 4 (in the accessories) on the hexagonal bolt 5 and
twist it.
–
Push the cutting block 6 downward.
–
Check whether the cutting block 6 and the knife 7 are parallel.
–
Tighten the screws 1, 2 and 3 again.
7 6 5 4