Attaching The Media Base - Roland ColorCamm PC-12 User Manual

Part 3 Getting Ready

Attaching the Media Base

Use the machine with the media base attached. The media base is designed for loading roll media.
The requires installation space for the machine with the media base attached is 900 (W) x 600 (D) x 500 (H) mm (35-7/16 (W) x 23-5/8 (D) x
19-11/16 (H) in.). Install it on a stable surface and do not place any obstructions at the front or rear.
On the back of the machine are two holes for inserting the
1
tabs on the media base. There are also two screw holes for
securing the media base in place after attaching it.
Remove the screws that are now in the screw holes.
A rating label is affixed to the back of the machine. Do not use with other than the rated power source. The rating
NOTICE
label is hidden when the media base is attached, so be sure to check the label before you attach the media base.
With the roller side of the media base facing up, insert the
2
tabs on the media base into the holes on the machine.
Use the screws to secure the media base in place.
3
22
Holes for inserting the tabs
on the media base
Screw holes for securing the
media base in place
Back of the machine
Rating
label