Specifying The Cutting Line - Roland ColorCamm PC-12 User Manual

The [Document Setup] dialog box reappears.
12
Click [Use Print Setup] to select it. This selects the check
box.
13 Click [OK].
14 The artboard size in Illustrator becomes the same size as the
printing size for the PC-12.
Create and edit the object so that it fits inside the artboard.
For Other Programs
With Illustrator, you set the printing size for the PC-12 by going to the [File] menu and choosing [Document Setup],
but depending on the program, the name of the command on the [File] menu may be different.
The names of the corresponding commands are [Print Setup], [Page Settings], [Page Setup], and so on. Make the
selection according to the program you're using. In any case, the dialog box that appears has a [Properties] button, so
click this button to make the settings.

Specifying the Cutting Line

NOTICE
For the cutting line, specify any RGB color other than black (RGB value of 0, 0, 0).
When the RGB value is set equal to 0, 0, 0, then depending on the program, it may not be correctly recognized as a
cutting-line color.
Use Illustrator 8.0 to specify the line that is to be cutting line.
Draw the line that is to be the cutting line. If it is already
1
drawn, then select it.
Specify the RGB value for the color of the line that is to be
2
the cutting line. Be sure to specify a color that is not used
elsewhere.
Make a note of the RGB value you specify, because you
will need it later when performing output.
Use RGB for the Color
When data is output to the PC-12, color information is sent as RGB values. Be sure to specify an RGB value to
ensure correct recognition as the cutting line color.
Part 4 Steps Up Through Printing and Cutting
Selects the check box.
Continued on the next page.
45