To Install Ink-Ribbon Cartridges - Roland ColorCamm PC-12 User Manual

Part 3 Getting Ready
If the indicator shown in the figure at right is
visible on an ink-ribbon cartridge, remove the
ink-ribbon cartridge before printing.
Also, do not install ink-ribbon cartridges in this
state.

To Install Ink-ribbon Cartridges

NOTICE
Do not attempt to rewind the ribbon.
Rewinding the ink ribbon may cause it to break.
Once an ink-ribbon cartridge has been used up, you cannot turn it over and reinstall it or rewind the ink ribbon and
reuse the ink-ribbon cartridge.
Install ink-ribbon cartridges with side B facing up. If an ink cartridge is with side B facing down, the unit determines
that the ink cartridge is not installed or is upside down, and the [error] light on the PC-12 flashes.
Do not attach ink-ribbon cartridges directly in the carriage. Doing so may result in breakdown or damage.
Up to nine ink-ribbon cartridge can be installed. Printing cannot be performed if ten are installed.
Make sure that two ink-ribbon cartridges installed in a single ink-ribbon cartridge holder are vertically aligned. If
their positions are not aligned a cartridge-change error may occur.
Each ink-ribbon cartridge holder is provided with an ink-ribbon anti-insertion plate. When installing and ink-ribbon
cartridge, take up any slack in the ink ribbon and make sure that it does not catch on the plate.
Be sure to eliminate any slack in the ink ribbon.
Closing the front cover while slackness remains may damage the ribbon in the ink-ribbon cartridge.
If you're using a new ink-ribbon cartridge, remove the
1
stopper.
26
The ink ribbon has run out.
S
topper