Loading Roll Media - Roland ColorCamm PC-12 User Manual

Loading Roll Media

Orient the roll media as shown in the figure, place it in the
1
media base, and bring it flush against the right stopper.
2 If the leading edge of the roll media is not straight, use a
commercially available cutter knife or the like to cut it
straight.
As shown in the figure at right, hold down the roll media
with your hand and cut the media using the cutter knife,
inserting the blade of the cutter knife into the knife-guide
groove and letting the groove guide the cutter knife.
3 Insert the media in the machine's feed unit. Insert the media
until it makes contact.
4 Press the [ready/insert] button once. The machine feeds the
media to the position where printing can be performed.
Part 3 Getting Ready
Bring flush against the right stopper.
Stopper
Media guide
Cutter guide
Continued on the next page.
35