1. Assembly and Ink Filling
Step 3: Installing the Media Holders and Media Stays
1. Attach the arms.
Procedure
1.
Temporarily tighten the bolts on the left stand as seen from the rear of the printer.
Tighten the bolts in the holes on the side of the stand until you can see approximately 5 mm
(0.2 in.) of their threads (A).
2.
Attach the left arm to the temporarily tightened bolts, and then slide this arm to the right.
MEMO
Each arm can only be used on the left (A) or right (B) side. Attach them on the correct sides.
3.
By hand, tighten the temporarily tightened bolts until there is no gap between the left arm and the
stand.
16
Installation