Connecting the Power Cord
Use the included power cord to connect the machine to an electrical outlet.
When you connect the machine to an electrical outlet, the machine performs setup for approximately five seconds.
During this interval the three lights on the operation panel light up. When setup ends the lights go out. You cannot
switch on the power to the machine while the lights are illuminated.
Power-cord
connector
Connecting to the Computer
To connect the machine and the computer, you can use either a parallel cable (IEEE 1284-compliant) or a USB cable.
Avoid using both types of cables at the same time to make the connection. Be sure to make the connection using only one or the other type of
cable.
Connection Using a Parallel Cable (IEEE 1284-compliant)
The parallel cable is sold separately. Use a cable suited to the configuration of the printer port on your computer.
NOTICE
Make the cable connections while the computer and the machine are switched off.
Computer
Power cord
Printer port
Rear left of the machine
Amphenol 36-pin
connector
Part 3 Getting Ready
23