1. Assembly and Ink Filling
Step 3: Installing the Media Holders and Media Stays
1. Attach arm A.
Procedure
1.
Temporarily tighten the bolts on the left stand as seen from the rear of the printer.
Tighten the bolts in the holes on the side of the stand until you can see approximately 5 mm
(0.2 in.) of their threads (A).
2.
Attach arm A (left) to the temporarily tightened bolts, and then slide this arm to the right.
MEMO
There are two different arm A parts: left (A) and right (B). Attach them on the correct sides.
3.
By hand, tighten the temporarily tightened bolts until there is no gap between the left arm and the
stand.
18
Installation