Orientation Of Originals - Canon 3300 Series Manual

Orientation of Originals

You can place the original either vertically or horizontally. Always align the top edge of your
original with the back edge of the platen glass (top left corner by the arrow) or the feeder.
2
IMPORTANT
•
If the top edge of the original is not aligned with the back edge of the platen glass (top left corner by
the arrow), prints may not be made correctly, depending on the mode you have set.
•
If an original is scanned facing the wrong direction, the sender information will not be printed at the
correct position on the fax.
NOTE
•
LTR and STMT-size originals can be placed either vertically or horizontally. However, the scanning
speed for horizontally placed originals is somewhat slower than for vertically placed originals.
•
You can place originals horizontally when printing with Preset Zoom mode, such as when processing
LTR
•
Horizontally placed LTR and STMT-size originals are referred to as LTRR and STMTR.
•
11" x 17" and LGL-size originals must be placed horizontally.
•
For instructions explaining how to set the original and available paper size/type, see the Reference
Guide.
2-8 Sending an Original
TX terminal ID
printed here
Place the original
face down
Vertical placement
TX terminal
ABC
ID printed here
Vertical placement
11" x 17".
[Platen glass]
[Feeder]
Place the original
face up
Place the original
face down
TX terminal ID printed here
Horizontal placement
TX terminal ID
printed here
Place the original face up
Horizontal placement