Multiple Communication Result Report - Canon 3300 Series Manual

Multiple Communication Result Report

This report is used to check whether documents were sent normally to the intended
destination when a sequential broadcast transmission was performed.
You can set whether or not to automatically print a sending result report after sending
documents by fax. (See 'Setting Automatic Output of a TX Report,' on p. 7-3.)
NOTE
•
The default setting for printing of the TX result report is "For error only."
•
You can also print a TX report with an image of the sent original attached to it. (See 'Setting
Automatic Output of a TX Report,' on p. 7-3.)
03/05 2001 MON 13:43 FAX 035 4892 5997
JOB NO.
PGS.
TX/RX INCOMPLETE
TRANSACTION OK
ERROR
1 JOB NO.
2 PGS.
9
3 DEPARTMENT ID
4 TX/RX
INCOMPLETE
5 TRANSACTION
OK
6 ERROR
9-4 Activity Management Reports and Lists
CANON
MULTI TX/RX REPORT
0014
Multi TX/RX Report
1
[ 11] 1234567890
-----
[ 10] 0987654321
A 4-digit number, that is automatically assigned when the sending document is
accepted, is printed.
The number of pages of the original that were normally sent to the remote party is
printed.
If Department ID Management is set, the Department ID is printed.
The telephone number of the sending destination to which you have not finished
sending is printed. If there is no applicable destination, "_ _ _" is printed.
The telephone number of the sending destination to which you have finished sending
is printed. If there is no applicable destination, "_ _ _" is printed.
When a sending error occurs, the telephone number of the sending destination is
printed. If there is no applicable destination, "_ _ _" is printed.
001
.
Canon CANADA
Canon U.S.A