Stamping Sent Or Scanned Originals (Stamping Original) - Canon 3300 Series Manual

Stamping Sent or Scanned Originals (Stamping Original)

The machine can print a stamp about 1/8" (3mm) in diameter on the front side of scanned or
sent originals. You can set the Stamp mode to differentiate scanned or sent originals.
Vertical placement
NOTE
•
Stamping originals can be set when the Feeder (DADF-H1) is attached.
•
When sending an original directly, you can set the machine so that the original is stamped either
after it has been sent, or after it has been scanned. (See 'Setting the Stamping Conditions,' on p. 5-
33.)
1
Place your originals in the feeder.
For instructions explaining how to set the original, see 'Sending an Original,' on p. 2-7.
2
Make sure the machine is ready to send, and press "Stamp."
A tick "
ABC
Position at which
stamp is applied
" appears in the box to the left of "Stamp."
Position at which
stamp is applied
Horizontal placement
Selecting the Sending Method
2
2-17