Dtc 1-5: Short To Ground In Driver's Airbag Lnflator - Honda EP3 Service Manual

SRS
1 6 .
DTC Troubleshooting (cont'd)
Turn the ignition switch ON {ll).
Check for voltage between the No. 7 terminal of
S R S u n i t c o n n e c t o r A ( 1 8 P ) a n d b o d y g r o u n d , t h e
N o . 1 6 t e r m i n a l a n d b o d y g r o u n d , t h e N o . 6
t e r m i n a l a n d b o d y g r o u n d , a n d t h e N o . 1 5 t e r m i n a l
and body ground. There should be 0.5 V or less.
SRS UNIT CONNECTOR A {18P)
1 1 .
Wire side ol lemale terminals
Is the voltage as specilied?
YES-Faulty SRS uniU replace the SRS unit (see
page 23-122) .a
NO Go to step 17.
Turn the ignition switch OFF.
Disconnect the cable reel from dashboard wire
harness B.
Turn the ignition switch ON (ll).
Check for voltage between the No. 7 terminal of
S R S u n i t c o n n e c t o r A ( 1 8 P ) a n d b o d y g r o u n d , t h e
N o . 1 6 t e r m i n a l a n d b o d y g r o u n d , t h e N o . 6
t e r m i n a l a n d b o d y g r o u n d , a n d t h e N o . 1 5 t e r m i n a l
and body ground. There should be 0.5 V or less.
ls the voltage as specitied?
Y E S R e p l a c e t h e c a b l e r e e l . l
N O - R e p l a c e d a s h b o a r d w i r e h a r n e s s B . l
1 8 .
1 9 .
20.
23-40
1 .
I J
L
DTC 1-5: Short to Ground in Driver's Airbag
lnflator
Special Tools Required
. SRS inflator simulator 07SM-TB4011A
. SRS simulator lead F 07XM-S230100
1. Erase the DTC memory (see page 23-26).
2. Turn the ignition switch ON (ll), and checkthatthe
SRS indicator comes on for about 6 seconds and
then goes oIf.
Does the SBS indicator stay on?
YES Go to step 3.
NO-lntermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-26).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the driver's airbag 4P connector (A)
from the cable reel.
07sAz-T84011A
07xaz-s230100
C o n n e c t t h e S R S i n f l a t o r s i m u l a t o r ( 2 0
connectors) and the simulator lead F to the cable
r e e t .
Reconnect the battery negative cable.
Erase the DTC memory.
a