Honda EP3 Service Manual page 1087

sRs
DTC Troubleshooting {cont'd)
8. Read the DTC.
Is DTC 1-3 indicated?
YES Go to step 9.
NO Short in the driver's airbag; replace the
driver's airbag (see page 23-'l 13).1
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect the front passenger's airbag 4P
connector from dashboard wire harness B (see step
3 o n p a g e 2 3 - 2 1 ) .
1 '1. Disconnect both seat belt tensioner 2P connectors
from the floor wire harness (see step 5 on page 23-
22t.
1 2 . D i s c o n n e c t S R S u n i t c o n n e c t o r A ( 1 8 P ) f r o m t h e
SRS unit (see step 7 on page 23-221.
13. Disconnectthe special tool from the cable reel.
23-38
I J
14. Check resistance between the No. 7 and the No. 16
t e r m i n a l s a n d b e t w e e n t h e N o . 6 a n d t h e N o . 1 5
t e r m i n a l s o f S R S u n i t c o n n e c t o r A ( 1 8 P ) . T h e r e
should be an open circuit, or at least 1 M Q .
SRS UNIT CONNECTOR A {18P)
GRN/WHT GRN/RED
GRN/YEL GRN/BLK
Wire side of female terminals
ls the rcsistance as specified?
YES Faulty SRS unit; replace the SRS unit (see
page 23-122],.a
NO Go to step 15.
Disconnect the cable reel from dashboard wire
harness B. Check resistance between the No,7 and
the No. 16 terminals and between the No. 6 and the
No. 15 terminals of SRS unit connector A (18P).
There should be an open circuit, or at least 1 M Q .
ls the resistance as specified?
YES Replace the cable reel.I
N O - R e p l a c e d a s h b o a r d w i r e h a r n e s s B . l