Half-Fold Position - Konica Minolta bizhub C203 Copy Operations

12
9
Check the print result.
– Check that the stapling position is adjusted to the center of the paper.
– If more adjustment is necessary, repeat steps 6 through 9.
12.8.2

Half-Fold Position

The folding position when printing with the "Half-Fold" setting can be adjusted for each paper size and for
each paper type.
Note
[Half-Fold Position] appears if optional finisher FS-609 is installed or optional finisher FS-519 is installed
with the saddle stitcher attached.
If the angle of the center folding position must be adjusted, contact your service representative.
!
Detail
For details on the "Center Staple & Fold" setting, refer to "Binding copies at the center ("Center Staple"
and "Half-Fold" setting/"Center Staple & Fold" setting)" on page 3-85.
0 Before making any adjustments, use the "Half-Fold" setting to print a single sample copy. Perform the
adjustment while checking the sample that was created.
1
Display the Administrator Settings screen.
– For details on displaying the Administrator Settings screen, refer to "Displaying the Administrator
Settings screen" on page 12-40.
2
Touch [1 System Settings].
The System Settings screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4
Touch [3 Finisher Adjustment].
The Finisher Adjustment screen appears.
5
Touch [2 Half-Fold Position].
The Half-Fold Position screen appears.
12-54
Finisher FS-519 + Saddle stitcher
Utility mode
bizhub C353/C253/C203 (FE2)