Utility mode
11.6
Finisher Adjustment
11.6.1
Half-Fold Position
The folding position when printing with the "Half-Fold" setting can be adjusted for each paper size and for
each paper type.
Note
[Half-Fold Position] does not appear if optional finisher and Saddle stitcher are not installed.
If the angle of the center folding position must be adjusted, contact your service representative.
!
Detail
For details on the "Center Staple & Fold" setting, refer to
Staple & Fold" setting)" on page
0
Before making any adjustments, use the "Half-Fold" setting to print a single sample copy. Perform the
adjustment while checking the sample that was created.
1
Display the Administrator Settings screen.
–
For details on displaying the Administrator Settings screen, refer to
Settings screen" on page
2
Touch [1 System Settings].
The System Settings screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4
Touch [3 Finisher Adjustment].
The Finisher Adjustment screen appears.
5
Touch [1 Half-Fold Position].
The Half-Fold Position screen appears.
6
Touch the button for the paper size to be adjusted.
–
If the paper size to be adjusted is not displayed, touch [↑] and [↓] until the desired paper size is
displayed.
7
Compare the width of the left pages of the copy sample with the width of the right pages to check for
the center of the paper.
–
If the folding position is too far to the left of the center of the paper, touch [+] to increase the
adjustment (between -5.0 and +5.0).
501/421/361
2-65.
11-35.
"Binding copies at the center ("Center
"Displaying the Administrator
11
11-39