Automatically Conserving Energy (Sleep Mode); Manually Conserving Energy - Konica Minolta bizhub C203 Copy Operations

2
2.3.7

Automatically conserving energy (Sleep mode)

If no operation is performed for a specified length of time, the machine automatically enters a mode where it
conserves energy.
Although the machine conserves more energy in Sleep mode than in Low Power mode, the machine must
warm up when Sleep mode is canceled to begin printing again, therefore taking more preparation time than
Low Power mode.
As the factory default, the machine enters Sleep mode after 20 minute.
To recover from Sleep mode
% Press the [Power Save] key.
– The touch panel comes on again and, after the machine
has finished warming up, it is ready to begin printing.
Note
The Sleep mode can also be canceled by pressing any key in the control panel or by touching the touch
panel.
!
Detail
As a default, the machine enters Low Power mode if no operation is performed for 15 minutes, and then
the machine enters Sleep mode after 20 minutes have elapsed.
The length of time until the machine enters Sleep mode can be changed. For details, refer to "System
Settings" on page 12-16 and page 12-24.
2.3.8

Manually conserving energy

The machine can be manually set to an energy conservation mode (Low Power mode or Sleep mode).
% Press the [Power Save] key (or press the sub power switch).
– As the factory default, the machine enters Low Power
mode.
!
Detail
Whether the machine enters Low Power mode or Sleep mode when the [Power Save] key is pressed
can be set from the Administrator Settings mode.
For details, refer to "System Settings" on page 12-24.
2-30
Before making copies
bizhub C353/C253/C203 (FE2)