12
8
Check that the distance from the starting print position of the
test pattern to the edge of the paper (b) is 3 mm (±0.5 mm).
–
If the distance is 2.4 mm or less, touch [+] to increase the
adjustment (between 0.2 mm and 3.0 mm).
–
If the distance is 3.6 mm or more, touch [-] to reduce the
adjustment (between -0.2 mm and -3.0 mm).
–
If the distance is between 2.5 mm and 3.5 mm, continue
with step 10.
–
Each time [+] or [-] is touched, the value is increased or
decreased by one increment.
9
Press the [Start] key.
The adjusted test pattern is printed.
10
Adjust the distance from the starting print position of the test pattern to the edge of the paper.
–
Check that the distance has been adjusted to between 2.5 mm and 3.5 mm.
–
If more adjustment is necessary, repeat steps 8 and 9.
–
To adjust the print position for a different paper tray, return to step 6.
11
Touch [OK].
–
To cancel the setting and select the default, press the [Reset] key.
The print position is adjusted.
12.7.3
Leading Edge Adjustment (Duplex Side 2)
The starting print position at the leading edge for the second side during automatic double-sided copying
with each type of paper (with respect to the paper feed direction) can be adjusted.
0
The starting print position is adjusted during manufacturing of the machine. Normally, the starting print
position will not need to be adjusted.
1
Display the Administrator Settings screen.
–
For details on displaying the Administrator Settings screen, refer to "Displaying the Administrator
Settings screen" on page 12-40.
2
Touch [1 System Settings].
The System Settings screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4
Touch [2 Printer Adjustment].
The Printer Adjustment screen appears.
5
Touch [3 Leading Edge Adjustment (Duplex Side 2)].
The Leading Edge Adjustment (Duplex Side 2) screen appears.
12-46
Utility mode
b
b: 3.0 mm ± 0.5 mm
bizhub C353/C253/C203 (FE2)