Alarm Connections - Bosch VIP X1 Installation And Operating Manual

EN | 40
Note
The numbering corresponds to the labeling of the video inputs on the
actual unit (VIP X2 only).
1. SNMP host address / 2. SNMP host address:
The VIP X supports the SNMP (Simple Network Management Protocol) for
managing and monitoring network components, and can send SNMP messages
to IP addresses. It supports SNMP MIB II and its traps in their full functionality in
the unified code. If you wish to send SNMP traps, enter the IP addresses of one
or two required target devices here.

Alarm connections

You can select the response of the VIP X in case of an alarm. In case of an alarm,
the VIP X can automatically establish a connection to a predefined IP address.
You can enter up to ten IP addresses which will be selected in order by the unit
in case of an alarm until a connection is established.
Connect on alarm:
Select On so that the VIP X automatically establishes a connection to a pre-
defined IP address in the event of an alarm.
Note
For alarm connections, always Stream 2 is transmitted. Take this into
account when assigning the profile (see page 31).
Configuration using a Web Browser
Installation and Operating Manual | VIP X1/VIP X2
Bosch Security Systems | 2005-10 | V1.5