Alarm Sources - Bosch VIP X1 Installation And Operating Manual

EN | 64

Alarm sources

You can configure the possible alarm triggers for the VIP X (for example the
alarm inputs).
Alarm input 1 ... Alarm input 4:
Select the option On in order to activate the alarm via the corresponding external
alarm sensor. Otherwise, select Off.
Select Active high if the alarm is to be triggered by closing the contact. Select
Active low if the alarm is to be triggered by opening the contact.
Name:
You can enter a name for each alarm input, which is then displayed below the
icon for the alarm input on the LIVEPAGE during configuration (see Livepage
configuration, page 82).
Video loss alarm:
Click the check box if you want interruption of the video signal to trigger an
alarm. A selected video input is marked with a tick.
Note
The numbering corresponds to the labeling of the video inputs on the
actual unit.
1. SNMP host address / 2. SNMP host address:
The VIP X supports the SNMP (Simple Network Management Protocol) for
managing and monitoring network components, and can send SNMP messages
to IP addresses. It supports SNMP MIB II and its traps in their full functionality in
Configuration using a Web Browser
Installation and Operating Manual | VIP X1/VIP X2
Bosch Security Systems | 2005-10 | V1.5