Bosch VIP X1 Installation And Operating Manual page 61

EN | 61
VIP X1/VIP X2 | Installation and Operating Manual
Audio settings (audio versions only)
You can set the gain of the audio signals to suit your specific requirements. The
current video image is shown in the small window next to the slide controls to
help you check the audio source and improve assignments. Your changes are
effective immediately.
You can also select the audio input that will be used. On the VIP X2 the line
inputs are automatically assigned to the corresponding video inputs.
Enable audio:
The audio signals are sent in a separate data stream parallel to the video data,
and so increase the network load. The audio data are encoded according to
G.711 and require an additional bandwidth of approx. 80 kBit/s per direction for
each connection. Select On if you wish to enable the audio function.
Line In 1 / Line In 2:
You can set the gain of the audio signal. The current level is displayed next to
the slide control to help you do this. Make sure that the display does not go
beyond the green zone during modulation.
Microphone (MIC):
You can set the gain of the microphone input. The current level is displayed next
to the slide control to help you do this. Make sure that the display does not go
beyond the green zone during modulation.
Bosch Security Systems | 2005-10 | V1.5 Configuration using a Web Browser