Chapter 2 Safety Information; Electric Shock Hazard - Bosch VIP X1 Installation And Operating Manual

VIP X1/VIP X2 | Installation and Operating Manual
Safety information

Electric shock hazard

Never attempt to connect the unit to any power network other than the type
for which it was intended.
Use only the power supply provided.
Never open the housing!
If a fault occurs, disconnect the power supply unit from the mains supply and
from all other devices.
Install the power supply and the unit only in dry, weather-protected areas.
If safe operation of the unit cannot be ensured, remove it from service and
secure it to prevent unauthorized start-up. Safe operation is no longer
possible in the following cases:
– if there is visible damage to the unit or power cables,
– if the unit no longer works properly,
– if the unit has been exposed to rain or moisture,
– if foreign matter has infiltrated the unit,
– after long storage under adverse conditions or
– after exposure to extraordinary transport stress.
In such cases, have the unit checked by Bosch Security Systems.
Bosch Security Systems | 2005-10 | V1.5
EN | 7
2
Safety information