Bosch VIP X1 Installation And Operating Manual page 66

EN | 66
Alarm connections
You can select the response of the VIP X in case of an alarm. In case of an alarm,
the VIP X can automatically establish a connection to a predefined IP address
(compatible MPEG-4 compatible hardware receiver or computer with reception
software). You can enter up to ten IP addresses which will be selected in order
by the unit in case of an alarm until a connection is established.
Connect on alarm:
Select On so that the VIP X automatically establishes a connection to a pre-
defined IP address in the event of an alarm.
Note
For alarm connections, always Stream 2 is transmitted. Take this into
account when assigning the profile (see page 56).
Number of destination IP address:
Here you assign the numbering for the IP addresses to be contacted in the event
of an alarm. The unit contacts the remote locations one after the other in the
numbered sequence until a connection has been established.
Destination IP address:
For each number, enter the corresponding IP address for the desired remote
location.
Destination password:
If the remote location is password protected, enter the password here.
Configuration using a Web Browser
Installation and Operating Manual | VIP X1/VIP X2
Bosch Security Systems | 2005-10 | V1.5