Changing Profiles - Bosch VIP X1 Installation And Operating Manual

EN | 32

Changing profiles

You can change individual parameter values within a profile and the name. You
can switch between profiles by clicking the associated tabs.
Warning!
The profiles are rather complex. They include a number of parameters that
interact with one another. Therefore it is generally best to use the default
profiles. The profiles should only be changed if you are completely familiar
with all the configuration options.
Note
The parameters as a group constitute a profile and are dependent on one
another. If you enter a setting outside the allowed range for a parameter,
the nearest valid value will be substituted when the settings are saved.
Profile name:
You can enter a new name for the profile here. The name is then displayed in
the list of available profiles in the Active encoder profile: field.
Target data rate:
To optimize utilization of the bandwidth in your network, you can limit the data
rate for the VIP X. The target data rate should be set according to the desired
picture quality for typical scenes with no excessive motion.
Configuration using a Web Browser
Installation and Operating Manual | VIP X1/VIP X2
Bosch Security Systems | 2005-10 | V1.5