Bosch VIP X1 Installation And Operating Manual page 72

EN | 72
Installation and Operating Manual | VIP X1/VIP X2
Attach JPEG from camera:
Click the checkbox to select the camera from which JPEG images will be sent.
An enabled camera input is indicated by a check mark.
Destination address:
Enter the e-mail address for alarm e-mails here. The maximum address length
is 49 characters.
Sender name:
Enter a unique name for the e-mail sender, for example the location of the
device. This will make it easier to identify the origin of the e-mail.
Send e-mail for testing:
Test the e-mail function by clicking Send now! An alarm e-mail will be immedi-
ately created and sent.
Relay
You can configure the switching behavior of the relay output. Open switch relay
(normally closed contact) or a closed switch relay (normally open contact) can
be specified.
It is also possible to specify whether the output should in a bistable or
monostable manner. In bistable operation, the activated state of the relay is
maintained. In monostable operation, the time can be selected after which the
relay reverts to its idle state.
You can choose various events that activate the output automatically. Thus, for
example, it is possible to switch on a spotlight in response to a motion alarm and
switch it off again when the alarm is over.
Configuration using a Web Browser Bosch Security Systems | 2005-10 | V1.5