Installing An Ac Power Supply In A J6300 Router - Juniper J2300 Getting Started Manual

J2300, J4300, and J6300 Services Router Getting Started Guide
8.
Figure 66: Removing an AC Power Supply

Installing an AC Power Supply in a J6300 Router

To install an AC power supply in a J6300 Services Router (see Figure 67):
1.
2.
3.
4.
5.
NOTE: Each power supply must be connected to a dedicated AC power feed. For
information about connecting to AC power sources, see "Connecting Power" on
page 102.
6.
182
Replacing Hardware Components
If you are not reinstalling a power supply into the emptied slot, install a blank
power supply panel over the slot.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to the ESD point on the chassis, or to an outside ESD point if
the router is disconnected from earth ground. For more information about
ESD, see "Preventing Electrostatic Discharge Damage" on page 221.
Using both hands, slide the power supply into the chassis until you feel
resistance.
Firmly push the power supply into the chassis until it comes to a stop. Make
sure that the power supply faceplate is flush with any adjacent power supply
faceplate.
Insert the appliance coupler end of a power cord into the appliance inlet on
the power supply faceplate.
Insert the power cord plug into an AC power source receptacle.
Verify that the power cord does not block access to router components or
drape where people might trip on it.