Installing A Pim - Juniper J2300 Getting Started Manual

J2300, J4300, and J6300 Services Router Getting Started Guide
Figure 56: Removing a PIM

Installing a PIM

CAUTION: Do not hot-swap PIMs. Failure to power off the router before removing
or installing a PIM might result in damage to the hardware.
To install a PIM (see Figure 57):
1.
2.
3.
CAUTION: Slide the PIM straight into the slot to avoid damaging the components
on the PIM.
4.
5.
166
Replacing Hardware Components
AL AR M
O N
PO W ER
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to the ESD point on the chassis, or to an outside ESD point if
the Services Router is disconnected from earth ground. For more information
about ESD, see "Preventing Electrostatic Discharge Damage" on page 221.
Press and release the power button to power off the router. Verify that the
LED blinks and then turns off.
POWER
Align the notches in the connector at the rear of the PIM with the notches in
the PIM slot in the Services Router, and slide the PIM in until it lodges firmly
in the router.
Tighten the captive screws on each side of the PIM faceplate.
Insert the appropriate cables into the cable connectors on the PIM.
ST AT US
1
G PO RT
C O N FI
ST AT US
0
PO RT
Captive screws