10G4Xa I/O Module; 10G4Ca I/O Module - Extreme Networks BlackDiamond 8800 Series Hardware Installation Manual

10G4Xa I/O Module

The 10G4Xa I/O module
Figure 14: 10G4Xa I/O Module
10GBASE-X XFP
Module status LEDs
The default configuration of the 10G4Xa I/O module is as follows. All ports:
Are added to the default VLAN as untagged
●
Inherit the properties of the default VLAN (for example, protocol type and VLANid)
●
The 10G4Xa I/O module has the following LEDs:
Module status
●
Module diagnostics
●
Port status
●
For information about the LEDs and their activity on the 10G4Xa I/O module, see
on page 38. For information about the XFP interfaces, see the Extreme Networks Pluggable Interface
Modules Installation Guide.

10G4Ca I/O Module

The 10G4Ca I/O module
connectors.
Figure 15: 10G4Ca I/O Module
10GBASE-CX4
Module status LEDs
The default configuration of the 10G4Ca I/O module is as follows. All ports:
Are added to the default VLAN as untagged
●
Inherit the properties of the default VLAN (for example, protocol type and VLANid)
●
The 10G4Ca I/O module has the following LEDs:
Module status
●
Module diagnostics
●
Port status
●
For information about the LEDs and their activity on the 10G4Ca I/O module, see
on page 38.
BlackDiamond 8800 Series Switches Hardware Installation Guide
(Figure 14) has four XFP-based 10-gigabit Ethernet ports.
10 Gbs ports
(Figure 14) has four 10-gigabit Ethernet ports that use CX4 interface
10 Gbs ports
10G4Xa 10G4Xa
41612
BD_155
"I/O Module LEDs"
10G4Ca 10G4Ca
41613
BD_156
"I/O Module LEDs"
I/O Modules
31