Table of Contents
Advertisement
GBIC, SFP (Mini-GBIC), QSFP+, XENPAK, and XFP
Regulatory Compliance
•
Invisible laser radiation can occur when the connectors are open. Avoid direct eye
exposure to the beam when optical connections are unplugged.
•
Never alter, modify, or change an optical device in any way other than suggested in
this document.
GBIC, SFP (Mini-GBIC), QSFP+, XENPAK, and XFP Regulatory Compliance
Extreme Networks pluggable optical modules and direct-attach cables meet the
following regulatory requirements:
•
Class 1 or Class 1M Laser Product
•
EN60825-1:2007 2nd Ed. or later, European standard
•
FCC 21 CFR Chapter 1, Subchapter J in accordance with FDA & CDRH requirements
•
Application of CE Mark in accordance with 2014/30/EU EMC Directive and the
2014/35/EU Low Voltage Directives
•
UL and/or CSA registered component for North America
•
47 CFR Part 15, Class A when installed into Extreme products
Cable Routing for LAN Systems
Extreme Networks equipment meets the requirements for LAN system equipment.
LAN systems are designed for intra-building installations; that is, cable runs between
devices must be in the same building as the connected units, except under the
conditions listed in the next paragraph.
As allowed in the USA by the National Electrical Code (NEC), this equipment can be
connected between buildings if any one of the following conditions is true:
•
Cable runs between buildings are less than 140 feet long.
•
Cable runs between buildings are directly buried.
•
Cable runs between buildings are in an underground conduit, where a continuous
metallic cable shield or a continuous metallic conduit containing the cable is
bonded to each building grounding electrode system.
Caution
Failure to follow these requirements for cable routing conditions may expose
the user to electrical shock and expose the unit to damage that can cause
errors.
74
ISW Series Managed Industrial Ethernet Switch Hardware Installation Guide
Safety and Regulatory Information
Advertisement
Table of Contents
