Remote Access - AT&T TL88102 User Manual

Answering system

Remote access

You can reach your answering system remotely by dialing your home
telephone number from any touch-tone telephone.
1. Dial your telephone number from any touch-tone telephone.
2. When the system plays your announcement, enter the two-digit
security code (19 is the default code. See page 66 to change it).
3. Once the new messages have played, you can also enter one of the
following remote commands.
Command
1
2
3
33
4
44
5
*5
6
*7
8
0
4. Hang up or press 8 to end the call.
NOTES:
• If you do not press any key after you enter the remote access code, all new messages play. If
there are no new messages, all old messages play.
• Once the new messages have played, the telephone announces the help menu options. If you
do not press any key within 20 seconds, the remote access call automatically disconnects.
• When the answering system is turned off, the telephone answers after 10 rings, and
announces, "Please enter your remote access code."
• When the memory is full, the answering system answers incoming calls after 10 rings and
announces, "Memory is full. Enter the remote access code."
Play all messages.
Play only new messages.
Delete the current message (during playback).
Delete all old messages.
Repeat the current message (during playback).
Skip to the previous message (during playback).
Stop.
Hear a list of remote commands.
Skip to the next message (during playback).
Record a new announcement.
End the call.
Turn the answering system on or off.
75
Function