Table of Contents
Advertisement
Answering system
Answering system settings
Remote access code
A two-digit security code is required to access the answering system
remotely from any touch-tone telephone. The preset code is 19. You can set
the code to any number from 00 to 99.
Using the telephone base:
1. Press the MENU soft key when the telephone base is not in use.
2. Press the SELECT soft key to select
3. Press
or p
q
CID
SELECT soft key. The corresponding icon,
4. Press
or p
q
CID
press the SELECT soft key.
5. Press
or p
q
CID
press the SELECT soft key.
6. Use the dialing keys (0-9) to enter a two-digit code.
Press CANCEL to delete a digit.
7. Then, press the SET soft key to confirm your setting.
There is a confirmation tone.
Using the handset:
1. Press the MENU soft key when the handset is not in use.
2. Press the SELECT soft key to select ANSWERING SYS.
3. Press
or p
q
CID
SELECT soft key. The corresponding icon,
4. Press
or p
q
CID
the SELECT soft key.
5. Press
or p
q
CID
the SELECT soft key.
6. Use the dialing keys to enter a two-digit code. Press
/CANCEL to delete a digit.
OFF
7. Then, press the SET soft key to confirm your setting.
There is a confirmation tone. You can also press the
BACK soft key to exit to the previous menu without
making any changes.
NOTE: If you change the remote access code setting on either Mailbox 1 or Mailbox 2, it
applies to both mailboxes in your answering system.
to select Answering sys.
to choose Mailbox 1 or Mailbox 2, then press the
DIR
to scroll to Ans sys setup, then
DIR
to scroll to Remote code, then
to scroll to
DIR
to choose Mailbox 1 or Mailbox 2, then press the
DIR
to scroll to Ans sys setup, then press
DIR
to scroll to Remote code, then press
DIR
or
1
1
or
66
flashes on the screen.
2,
# of rings
Remote code
Msg alert tone
REMOTE CODE
, flashes on the screen.
2
ANS SYS SETUP
# of rings
Remote code
Msg alert tone
BACK
REMOTE CODE
BACK
1
SELECT
1
__
SET
1
SELECT
1
__
SET
Advertisement
Table of Contents
