Remote Access Code - AT&T BL102-3 Complete User's Manual

Answering system
Answering system settings
5. Press q or p
CID
• Toll saver - the answering system answers a call after two rings when
you have new messages, and after four rings when there are no new
messages. This feature allows you to check for new messages and avoid
paying long distance charges when calling from out of your local area.
/SELECT to save the setting. You hear a confirmation tone.
6. Press
MENU
Press CANCEL to cancel.
OFF/
NOTES:
If you subscribe to voicemail service through your telephone service provider, see Answering system and
f
voicemail indicators on page 77.
If you set the number of rings for the answering system as two or three rings, the caller ID announce feature may
f
not have enough time to announce the caller's full information.

Remote access code

To access your answering system remotely from any touch-tone phone, you
need to enter a two-digit number (00-99). By default, the remote access code
is 19.
To change the remote access code:
1. When the handset is in idle mode, press MENU/
enter the main menu.
2. Press q or p
CID
/SELECT.
press
MENU
3. Press q or p
CID
press /SELECT.
MENU
4. Press q or p
CID
/SELECT.
MENU
5. Use the dialing keys to enter a two-digit number. Press
/DELETE to backspace and delete a digit.
MUTE
6. Press /SELECT to save the setting.
MENU
to scroll and choose among 2, 3, 4, 5, 6 or Toll saver.
DIR
to scroll to Answering sys, then
DIR
to scroll to Ans sys setup, then
DIR
to scroll to Remote code, then press
DIR
SELECT
75
to
Ans sys setup
ECO
Remote code
ECO
Remote code
ECO
19