Appendix; Adding And Registering Handsets; Register A Handset To The Telephone Base - AT&T TL88102 User Manual

Appendix

Adding and registering handsets

The handset provided with your telephone system is already registered
as HANDSET. Additional handsets registered to the telephone system are
assigned in sequential order. If you register another new handset to your
telephone system, the new registered handset is assigned HANDSET 2.
Then your first handset is renamed as HANDSET 1. This telephone system
accommodates up to 12 handsets.
You can add new handsets (TL88002, purchased separately) to your
telephone system, but each handset must be registered with the telephone
base before use. When first purchased, each expansion handset shows
Press [HOLD] on base for 4 sec, then press [#] on handset. You may need
to charge the handset before registering to the telephone base. For more
details on battery charging, see the table on page 8.

Register a handset to the telephone base

1. Before you begin registration, make sure the handset displays Press
[HOLD] on base for 4 sec, then press [#] on handset.
2. Place the unregistered handset in the telephone base.
3. Press and hold HOLD on the telephone base for about four seconds until
the telephone base displays Registering handset... While the handset
is still in the telephone base, press # (pound key) on the handset. The
handset shows Registering... Please wait and it takes up to 60 seconds
to complete the registration. The handset and the telephone base show
HANDSET X Registered (X represents the handset number assigned) and
you hear a beep when the registration completes.
NOTES:
• If the registration fails, the handset shows Registration failed. To reset the handset, unplug
the power from the telephone base and the battery from the handset for a few seconds then
plug them back in. Try the registration process again.
• You cannot register a handset if any other system handset is in use.
HOLD
#
76