Call Transfer Using Intercom; Transfer A Call - AT&T TL88102 User Manual

Multiple Handset use

Call Transfer using intercom

Using the intercom feature to transfer an outside call to another system
handset or the telephone base. You can also share an outside call with
another system handset or the telephone base.

Transfer a call

From the handset:
1. During a call, press INT.
2. When you have only one system handset, your handset shows
Calling base and the telephone base rings and shows Handset is calling.
The outside call is put on hold automatically.
-OR-
When you have more than one system handset, the originating handset
shows INTERCOM TO:, press
press the SELECT soft key. The outside call is put on hold automatically.
• If you are calling the telephone base, your handset shows Calling base
and the telephone base rings and shows Handset X is calling.
• If you are calling another handset, your handset shows
Calling handset X and the destination handset rings and shows
Other handset is calling or Handset X is calling.
3. To answer the intercom call, press
telephone base, or press LINE 1/
INT on the handset. The outside call is still on hold. Both the originating
handset and the destination handset or the telephone base now show
Intercom. You can now have a private conversation between the handset
and the telephone base or between the two handsets.
NOTES:
• If you want to cancel an intercom call and reconnect to the outside call before the
destination handset or telephone base answers, press the corresponding line button,
LINE 1/
FLASH
• If the destination handset or telephone base does not answer the intercom call within 100
seconds, is in the directory or call log, or is out of range, your originating handset shows
Unable to call try again and the outside call is still on hold. Press the corresponding line
button, LINE 1/
outside call.
4. Press OFF or the END soft key on the originating handset. Both screens
show Intercom ended.
5. The originating handset and the destination handset or telephone base
show L1)ON HOLD if the call is on line 1. Press LINE 1/
destination handset or press
procedures apply if the call is on line 2.
or LINE 2/
, on your originating handset.
FLASH
or LINE 2/
FLASH FLASH,
or p to select a destination and then
q
CID DIR
/LINE 1 or
, LINE 2/
FLASH
on your originating handset to reconnect to the
/LINE 1 on the telephone base. The same
34
/LINE 2 on the
, /SPEAKER or
FLASH
on the
FLASH