Table of Contents
Advertisement
Answering system
Answering system settings
Remote access code
To access your answering system remotely from any touch-tone phone, you
need to enter a two-digit number (00-99). By default, the remote access
code is 19.
To change the remote access code:
Using a cordless handset or telephone base:
1. Press
MENU/
2. Press
or
CID
/SELECT
MENU
3. Press
or
CID
/SELECT
MENU
4. Press
or
CID
/SELECT
MENU
5. Use the dialing keys to enter a two-digit number.
-OR-
Press
or
CID
/SELECT
6. Press
MENU
Message alert tone
When the message alert tone is set to On, and there is at least one new
message, the telephone base beeps every 10 seconds. The tone stops when all
new messages have been reviewed. By default, the message alert tone is Off.
To turn on or off the message alert tone:
Using a cordless handset or telephone base:
MENU/
1. Press
2. Press
or
CID
3. Press
or
CID
in idle mode.
SELECT
to highlight Answering sys, then press
DIR
.
to highlight Ans sys setup, then press
DIR
.
to highlight Remote code, then press
DIR
.
to scroll to a desired two-digit number.
DIR
to confirm.
in idle mode.
SELECT
to highlight Answering sys, then press
DIR
to highlight Ans sys setup, then press
DIR
129
Remote code
ECO
Remote code
ECO
/SELECT
.
MENU
/SELECT
.
MENU
19
Advertisement
Table of Contents
