Battery Installation And Charging - AT&T TL88102 User Manual

Getting started

Battery installation and charging

Install the battery as shown below. Once you have installed the battery, the
screen indicates the battery status (see the table below). If necessary, place
the handset in the telephone base or charger to charge the battery. For best
performance, keep the handset in the telephone base or charger when not in
use. The battery is fully charged after 16 hours of continuous charging.
If the screen shows Place handset in charger and
charge the handset without interruption for at least 30 minutes to give the
handset enough charge to use the telephone for a short time. The following
table summarizes the battery charge indicators and actions to take.
Battery indicators
The screen is blank, or
shows Place handset in
charger and
(flashing).
The screen shows
Low battery and
The screen shows
HANDSET X.
NOTE: If you are on a phone call in low battery mode, you hear four short beeps every
minute.
Battery status
Battery has no or very little
charge. The handset cannot
be used.
Battery has enough charge
(flashing). to be used for a short time.
Battery is charged.
Step 1
Plug the battery
connector securely
into the socket inside
the handset battery
compartment. Insert
the supplied battery
with the label THIS
SIDE UP facing up as
indicated.
flashes, you need to
Action
Charge without interruption
(at least 30 minutes).
Charge without interruption
(at least 30 minutes).
To keep the battery charged,
place it in the telephone base or
charger when not in use.
8
Step 2
Align the cover flat
against the battery
compartment, then
slide it upwards until
it clicks into place.