Denso BHT-904B User Manual page 180

BHT-904B/BHT-914B
Message
166
BHT Response
The message continues to
display.
If this error occurs, the BHT
beeps five times and then
turns itself off.
The BHT displays this error
message and automatically
runs the execution program
from the point of start-up.
After displaying this error
message, the BHT may
start a user program other
than the preset auto-start
execution program or
display the message "No
execution program loaded."
If this error occurs, the BHT
beeps five times.
Cause
When the BHT is turned on, no
user programs are found.
Any of the hardware error,
memory error and
execution program error
has occurred.
(XXXX: Error code)
Operation was terminated
without turning OFF the
power normally with the
resume function set, and
therefore resume info has
been lost.
Your settings made in
System Mode contain an
error.
An error has occurred
during execution of System
Program.
Countermeasure
Contact your system
administrator.
To carry out scanning
demo, select [2: Code
scanning demo]. To carry
out barcode scanning
demo, press the trigger
switch.
To activate the easy
operation application
software "Easy Pack Ad for
BHT-900", select [1: Easy
Pack Ad]. For details, refer
to the manual
accompanying with the
application.
Turn the BHT on again.
If this error occurs
frequently, make a note of
the displayed code and
contact your system
administrator.
If this error occurs
frequently, make a note of
the displayed code and
contact your system
administrator.
Contact your system
administrator. (If this error
occurs, the System Mode
settings revert to the
factory defaults.)
Unload and reload the
battery and then turn the
BHT ON.
If this error occurs
frequently, contact your
system administrator.