Installation; Positioning The Antenna; Connecting The Gps Antenna; Connecting The Wwan (Cellular) Antenna - Apollo VioNet 3000 series User Manual And Instruction Manual

Vionet 3000 series mobile router
Hide thumbs Also See for VioNet 3000 series:
Table of Contents

Advertisement

2.0

Installation

2.1

Positioning the Antenna

The orientation of the antenna is critical for optimal performance. In order to achieve the best coverage, follow these
instructions:
Mount antennas a minimum of 18 inches from one another.
Place the antenna where there are no physical obstacles between the antenna and base station in
order to limit degradation of the wireless signal.
Antennas should be positioned away from metal screens, mirrors or other dense materials as they may
affect performance.
Antennas should be positioned away from other wireless devices and/or radiation devices
(communication devices, personal computers, etc.)
Insulate the antenna with rubber or a ground plate.
Utilize caulk to secure and waterproof the base of the antenna.
Tape any un-used connectors and all metal connectors once connected to prohibit conductivity.
If there is additional cable length, individually loop each cable into a separate coil and utilize zip ties to
hold in coiled position.
Do not touch or move the antenna while the device is transmitting or receiving.
Antennas and cables should be those supplied or recommended by Apollo Video Technology.
2.2

Connecting the GPS Antenna

NOTE:
GPS Antenna cables are labeled "3V – 5V GPS"
For best results, mount the GPS Antenna toward the center of the vehicle.
Connect the antenna cable connector into the connector labeled "GPS" located on the front panel of the
2.2.1
device.
2.3

Connecting the WWAN (Cellular) Antenna

NOTE: Cellular Antenna cables are labeled "1700 – 2700 MHz".
Connect the antenna cable to the connectors labeled "CELL1" and CELL2", located on the front panel of the
2.3.1
device.
NOTE:
The VioNet Router has two connectors incorporated (ANT.1 and ANT.2) for each module
installed in the device (CELL1 and CELL2):
The MAIN antenna for each module (CELL1 and CELL2) is installed in the ANT.1 connector.
The DIVERSITY antenna for each module (CELL1 and CELL2) is installed in the ANT.2
connector.

Figure 3: GPS Antenna Connector

Apollo Video Technology
th
Avenue Southeast – Bothell, WA 98021-8990
24000-35
Toll Free: 888-AVT-USA1; Tel: 425.483.7100; Fax: 425.483.7200
www.apollovideo.com
VioNet 3000 Series Mobile Router | User Guide
Page 7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vn-3001Vn-3011aVn-3011bVn-3021c

Table of Contents