Configuration; Power Management; Figure 11: Power Management Switch / Microswitches - Apollo VioNet 3000 series User Manual And Instruction Manual

3.0

Configuration

3.1

Power Management

3.1.1 Configuring Power Management
The Router contains a power management system with the following features:

The device will only switch on when the vehicle ignition has been switched on.

When installed, the device switches off a short time after the vehicle has been switched off, i.e. there is
a slight delay with respect to the vehicle being switched off.
connection even during short stops.
This feature is configured through the internal microswitches (SW100). However, the duration of the delay is
configured through the configuration command.
3.1.2 Deactivating Power Management (Ignition Sense)
The SW100 microswitches 1 and 2, labeled as IGNITION, must be in the OFF position.
NOTE: This is a factory setting, i.e. the devices are already configured in this mode by the factory.
3.1.3 Activating Power Management
The SW100 microswitches 1 and 2, labeled as IGNITION, should be in the ON position
In this operating mode, the device expects to be constantly powered and the ACC / IGNITION signal
operates as a switch. When power is applied to the device (BATTERY / VCC) the device remains switched
off. It will only switch on when the signal (12V) is applied to the ignition pin (ACC / IGNITION).
Similarly, if the ignition signal deactivates once the device has switched on, the device will remain switched
on for the period of time configured through the "set ignition-off-powerdown-timer <value>" command.

Figure 11: Power Management Switch / Microswitches

Apollo Video Technology
th
Avenue Southeast – Bothell, WA 98021-8990
24000-35
Toll Free: 888-AVT-USA1; Tel: 425.483.7100; Fax: 425.483.7200
www.apollovideo.com
VioNet 3000 Series Mobile Router | User Guide
The feature allows for a constant
Page 11