Microswitches; Reset To Default Configuration; Figure 27: Sample Message, Configuration Console - Apollo VioNet 3000 series User Manual And Instruction Manual

5.0

Microswitches

The VioNet Router has a block of 8 microswitches (SW2) available that are used for maintenance and test tasks.
In this case, they are only used to load the default configuration.
This block of microswitches can be found inside the VioNet Router. The top casing must be removed in order to
handle them.
These switches should not be handled by the user except to establish the default configurations.
NOTE: In order for the device to operate correctly, all the microswitches must be in the OFF position.
5.1

Reset to Default Configuration

This "Reset to Default Configuration" procedure can be applied to discard the whole configuration of the
device, for example, if the password cannot be remembered.
The procedure is as follows:
* Turn off the device by removing power.
Using a screwdriver move micro-switch '5' on SW2 to the ON position.
*
* Turn the device ON by applying power.
When the device is switched on, a message similar to the one following will appear on the configuration console:
**************************************************
**************************************************
**************************************************
BOOT CODE VERSION: 03.02
gzip Apr 28 2009 11:19:34
P.C.B.: C8 MASK:0C10
START FROM FLASH
BIOS CODE DUMP....................
BIOS DATA DUMP....
End of BIOS dump
BIOS CODE VERSION: 03.02
CLK=262144 KHz
Date: 05/25/09, Monday
SDRAM size: 64 Megabytes
BANK 0: 64 Megabytes (detected)
I_Cache: ON
D_Cache: ON
FLASH: 16 Mb.
NVRAM: 128 Kb.
EEPROM: 2048 Bytes.
DPRAM: 8192 Bytes.
SWITCH 10/100
SECURITY ENGINE
PCI device: Host bridge
(Bus: 0, Device: 0, Function: 0)
(Vendor: 0x1057, Device: 0x18C1)
(Subs. Vendor: 0x0000, Subs. Device: 0x0000)
Slot 1 - PCI device: serial bus controller
(Bus: 0, Device: 10, Function: 0)
(Vendor: 0x1131, Device: 0x1561)
(Subs. Vendor: 0x5444, Subs. Device: 0x2800)
Slot 1 - PCI device: serial bus controller

Figure 27: Sample Message, Configuration Console

Apr 28 2009 11:25:37
Microcode:00E1
BUSCLK=65536 KHz PCICLK=32768 KHz
Time: 13:37:06
Write-Back
Apollo Video Technology
th
Avenue Southeast – Bothell, WA 98021-8990
24000-35
Toll Free: 888-AVT-USA1; Tel: 425.483.7100; Fax: 425.483.7200
www.apollovideo.com
VioNet 3000 Series Mobile Router | User Guide
L1
Page 19