Product Usage Restrictions; Figure 38: Configuration Connector (Db9) - Apollo VioNet 3000 series User Manual And Instruction Manual

11.5

Product Usage Restrictions

This product is designed for in-vehicle or indoor usage only. Outdoor usage is not recommended, unless
otherwise noted. See Specifications for environmental IP rating.
2.4 GHz Restrictions: This product is designed for use with the antennas defined by the manufacturer.
5 GHz Restrictions: This product is designed for use indoors only when using channels 36, 40, 44, 48, 52, 56,
60 or 64 (5150-5350 MHz).
The Dynamic Frequency Selection and the Transmission Power Control are enabled in order to guarantee the
product fully complies with the CE standards.
Wireless devices can cause interference in other devices. Do not use the device in areas where medical
equipment is installed.
11.5.1 Third-Party Software or Firmware
The use of software or firmware not supported/provided by Apollo Video Technology may result that the
equipment is no longer compliant with the regulatory requirements
11.5.2 FCC Regulatory Approval and Compliance
11.5.2.1 Modification
Any changes or modifications could void the user's authority to operate the equipment.
11.5.2.2 Interference
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
11.5.2.3 Wireless
This equipment complies with FCC exposure limits set forth for an uncontrolled environment. The
antennas should be installed and operated with minimum distance of 20 cm between the radiator
and a human body. Antenna gain must be below the following:

Figure 38: Configuration Connector (DB9)

RJ45 PIN
1
2
3
4
5
6
7
8
Apollo Video Technology
th
Avenue Southeast – Bothell, WA 98021-8990
24000-35
Toll Free: 888-AVT-USA1; Tel: 425.483.7100; Fax: 425.483.7200
www.apollovideo.com
VioNet 3000 Series Mobile Router | User Guide
CONF
--
RxD
TxD
--
GND
--
--
--
Page 181