Monitoring - Apollo VioNet 3000 series User Manual And Instruction Manual

line 7 -> list interf eth1
(lines counting since last log-command-erros command)
Too many errors, some cannot be printed (printed 5 of 8)
Config>
6.5.6 Return to Previous Configuration
Return to the previous configuration is activated through the "CONFIRM-CFG-NEEDED" command.
This requires the confirmation of the saved configuration. If you have executed this command, the
configuration is saved in TEMP.CFG in order to be checked. If, after restarting, the configuration is not
confirmed with the confirm-cfg command within the configured time, the device will restart with the
previous configuration. If the configuration is confirmed it, is saved with the corresponding name i.e. the
use of TEMP.CFG is transparent to the user. Should the new configuration make the device restart
before the programmed test time is reached, if after ten restarts without the configuration being
confirmed, the previous configuration will be restored. If you execute the no confirm-cfg command,
the device will restart with the previous configuration. The no confirm-cfg-needed command disables
the need to confirm the newly saved configurations.
Config>confirm-cfg-needed <option>
default Enables the need of configuration confirmation
timeout Sets a timeout to wait for confirmation
<option> specifies the selected action.
6.5.6.1
Config>confirm-cfg-needed default
6.5.6.2
Config>confirm-cfg-needed timeout <time>
<option> specifies the test time in any of the following formats: Xw, Xd, Xh, Xm, Xs, HH:MM, HH:MM:SS.
NOTE: Time duration must be set between one (1) and five (5) minutes.
6.5.6.3
Config>confirm-cfg
6.6

Monitoring

6.6.1 Configuring a Gateway
Displays protocol and network interface information. The output presented by this command can be
divided into the sections:

Data such as the router identification, software version, boot ROM version, and the state of the
watchdog, as well as the device date and time together with the length of time since the last
reboot.

Information regarding protocols that can be monitored and the current interfaces.
*p 3
Console Operator
+configuration
Teldat's Router, H1 Auto.+ 2M LTE GPS WLAN IPSec SNA VoIP T+ 29 12
P.C.B.=18 Mask=0c10
ID: TH1A+-16F64R L29.12
Boot ROM release:
BIOS CODE VERSION: 04.06
Page 28
CONFIRM-CFG-NEEDED DEFAULT
Requires confirmation of saved configurations with a test time of 10 minutes.
CONFIRM-CFG-NEEDED TIMEOUT
Configures the new configuration test time.
CONFIRM-CFG
Confirms the current configuration. The configuration must be saved with the
configuration confirmation function activated.
Microcode=00e1
Jun 21 2012 11:03:49
Apollo Video Technology
th
Avenue Southeast – Bothell, WA 98021-8990
24000-35
Toll Free: 888-AVT-USA1; Tel: 425.483.7100; Fax: 425.483.7200
www.apollovideo.com
CLK=400000 KHz BUSCLK=100000 KHz
S/N: 777/000112