Wall Mounting
The FortiFone-450i/FortiFone-550i phone supports wall mounting via the base of the phone
housing. Wall mount the FortiFone-450i/FortiFone-550i using the instructions below in
Figure 4.
•
Mark and drill two 7 mm (5/16") holes for plastic wall anchors (not included) with a
vertical separation of 10 cm (4").
•
Insert two anchors into the holes, then insert and tighten the two screws (not
included) leaving about 2.5 mm (1/8") exposed.
•
Attach all wiring to the phone.
•
Slide the phone over the screws and ensure the phone is secure. Note it may be
necessary to remove the phone and tighten or loosen the screws for secure mounting.
Also note, the stand must not be attached to the phone when mounting on a wall.
•
Remove the handset hook from the phone as shown in the figure below. Reverse the
hook and re-install in the phone so that the hook catches the groove in the handset
receiver.
•
Complete all wiring.
Figure 4: FortiFone-450i/FortiFone-550i Wall Mount Installation
F O R T I F O N E - 4 5 0 i A N D F O R T I F O N E - 5 5 0 i T E L E P H O N E S T A R T G U I D E
1 1