Table of Contents
Advertisement
WALL MOUNTING
The FortiFone-350i phone supports wall mounting via the base of the phone housing. Wall mount the
FortiFone-350i using the instructions below in Figure 4.
•
Mark and drill two 7 mm (5/16") holes for plastic wall anchors (not included) with a vertical
separation of 10 cm (4").
•
Insert two anchors into the holes, then insert and tighten the two screws (not included) leaving about
2.5 mm (1/8") exposed.
•
Attach all wiring to the phone.
•
Slide the phone over the screws and ensure the phone is secure. Note it may be necessary to remove
the phone and tighten or loosen the screws for secure mounting. Also note, the stand must not be
attached to the phone when mounting on a wall.
•
Remove the handset hook from the phone as shown in the figure below. Reverse the hook and re-
install in the phone so that the hook catches the groove in the handset receiver.
•
Complete all wiring.
Figure 4: FortiFone-350i Wall Mount Installation
1 2
F O R T I F O N E - 3 5 0 i T E L E P H O N E U S E R G U I D E
Advertisement
Table of Contents
Troubleshooting
