General Steps For Configuring Snmp Notifications - HP PROCURVE 2520 Management And Configuration Manual

Configuring for Network Management Applications
Using SNMP Tools To Manage the Switch
■
■

General Steps for Configuring SNMP Notifications

To configure SNMP notifications, follow these general steps:
1. Determine the versions of SNMP notifications that you want to use in your
2. To reconfigure any of the SNMP notifications that are enabled by default
3. (Optional) Refer to the following sections to configure optional SNMP
13-18
Advance Traffic Management Guide:
• Loop protection
• Spanning Tree (STP, RSTP, MSTP)
Access Security Guide:
• MAC lockdown
• MAC lockout
network.
If you want to use SNMPv1 and SNMPv2c traps, you must also configure
a trap receiver. Refer to the following sections and follow the required
configuration procedures:
• "SNMPv1 and SNMPv2c Traps" on page 13-19
• "Configuring an SNMP Trap Receiver" on page 13-19
• "Enabling SNMPv2c Informs" on page 13-21
If you want to use SNMPv3 notifications (including traps), you must also
configure an SNMPv3 management station. Follow the required configu­
ration procedure in the following section:
• "Configuring SNMPv3 Notifications" on page 13-23
to be sent to a management station (trap receiver), refer to these sections:
• "Enabling Link-Change Traps" on page 13-28
notification features and verify the current configuration:
• "Configuring the Source IP Address for SNMP Notifications" on page
13-29
• "Displaying SNMP Notification Configuration" on page 13-31