Using Tftp To Download Switch Software From A Server; Menu: Tftp Download From A Server To Primary Flash - HP PROCURVE 2520 Management And Configuration Manual

File Transfers
Downloading Switch Software
N o t e
Downloading new switch software does not change the current switch con­
figuration. The switch configuration is contained in separate files that can also
be transferred. Refer to "Transferring Switch Configurations" on page A-22.
In most cases, if a power failure or other cause interrupts a flash image
download, the switch reboots with the image previously stored in primary
flash. In the unlikely event that the primary image is corrupted (which may
occur if a download is interrupted by a power failure), the switch goes into
boot ROM mode. In this case, use the boot ROM console to download a new
image to primary flash. Refer to "Restoring a Flash Image" on page C-68.
Using TFTP To Download Switch Software from a
Server
This procedure assumes that:
■
■
■
Before you use the procedure, do the following:
■
■
■
N o t e
If your TFTP server is a UNIX workstation, ensure that the case (upper or
lower) that you specify for the filename is the same case as the characters
in the software filenames on the server.

Menu: TFTP Download from a Server to Primary Flash

Note that the menu interface accesses only the primary flash.
1. In the console Main Menu, select Download OS to display the screen in
A-4
A software version for the switch has been stored on a TFTP server
accessible to the switch. (The software file is typically available from the
ProCurve Networking web site at www.procurve.com.)
The switch is properly connected to your network and has already been
configured with a compatible IP address and subnet mask.
The TFTP server is accessible to the switch via IP.
Obtain the IP address of the TFTP server in which the software file has
been stored.
If VLANs are configured on the switch, determine the name of the VLAN
in which the TFTP server is operating.
Determine the name of the software file stored in the TFTP server for the
switch (for example, E0820.swi).
figure A-1. (The term "OS", or "operating system" refers to the switch
software):