Viewing The Current Configuration - HP PROCURVE 2520 Management And Configuration Manual

Viewing the Current Configuration

Displaying the Global LLDP, Port Admin, and SNMP Notification
Status. This command displays the switch's general LLDP configuration
status, including some per-port information affecting advertisement traffic
and trap notifications.
Syntax show lldp config
For example, show lldp config produces the following display when the switch
is in the default LLDP configuration:
ProCurve(config)# show lldp config
LLDP Global Configuation
LLDP Enabled [Yes] : Yes
LLDP Transmit Interval
LLDP Hold time Multiplier
LLDP Delay Interval
LLDP Reinit Interval
LLDP Notification Interval [5] : 5
LLDP Fast Start Count
LLDP Port Configuration
Port | AdminStatus NotificationEnabled Med Topology Trap Enabled
----- + ----------- ------------------- ------------------------ -
1 | Tx_Rx
2 | Tx_Rx
3 | Tx_Rx
4 | Tx_Rx
5 | Tx_Rx
Figure 13-14. Example of Viewing the General LLDP Configuration
Displays the LLDP global configuration, LLDP port status, and
SNMP notification status. For information on port admin status,
refer to "Configuring Per-Port Transmit and Receive Modes" on
page 13-49.
[30] : 30
[4] : 4
[2] : 2
[2] : 2
[5] : 5
False
False
False
False
False
Configuring for Network Management Applications
LLDP (Link-Layer Discovery Protocol)
Note: This value corresponds to
the lldp refresh-interval
command (page 13-45).
False
False
False
False
False
13-43