HP PROCURVE 2520 Management And Configuration Manual page 190

Time Protocols
SNTP: Viewing, Selecting, and Configuring
==========================- CONSOLE - MANAGER MODE -========================
System Name : ProCurve
System Contact :
System Location :
Inactivity Timeout (min) [0] : 0
Inbound Telnet Enabled [Yes] : Yes
Time Sync Method [None] : TIMEP
TimeP Mode [Disabled] : Disabled
Tftp-enable [Yes] : Yes
Time Zone [0] : 0
Daylight Time Rule [None] : None
Actions-> Cancel
Figure 9-1. The System Information Screen (Default Values)
2. Press [E] (for Edit). The cursor moves to the System Name field.
3. Use [v] to move the cursor to the Time Sync Method field.
4. Use the Space bar to select SNTP, then press [v] once to display and move
5. Do one of the following:
Figure 9-2. Time Configuration Fields for SNTP with Broadcast Mode
9-6
Switch Configuration - System Information
Edit Save
to the SNTP Mode field.
• Use the Space bar to select the Broadcast mode, then press
move the cursor to the Poll Interval field, and go to step 6. (For
Broadcast mode details, refer to "SNTP Operating Modes" on
page 9-2.)
Time Sync Method [None] : SNTP
SNTP Mode [Disabled] : Broadcast
Poll Interval (sec) [720] :
Tftp-enable [Yes] : Yes
Time Zone [0] : 0
Daylight Time Rule [None] : None
• Use the Space bar to select the Unicast mode, then do the
following:
[>]
to move the cursor to the Server Address field.
i. Press
ii. Enter the IP address of the SNTP server you want the switch to
use for time synchronization.
MAC Age Time (sec) [300] : 300
Web Agent Enabled [Yes] : Yes
Time Protocol Selection Parameter
– TIMEP
– SNTP
– None
Help
720
[v]
to