Viewing Port Status And Configuration - HP PROCURVE 2520 Management And Configuration Manual

Viewing Port Status and Configuration

Use the following commands to display port status and configuration data.
Syntax: show interfaces [ brief | config | < port-list >]
An example of the show interfaces brief command is shown below.
ProCurve(config)# show interfaces brief
Status and Counters - Port Status
Port Type
----- --------- + --------- ------- ------ ---------- ----- ----- ------
1 10/100TX
2 10/100TX
3 10/100TX
4 10/100TX
5 10/100TX
6 10/100TX
Figure 10-3. Example of show interfaces brief Command Listing
Use the show interfaces config command to view the port settings, as shown
below.
broadcast-limit
auto-mdix
brief: Lists the current operating status for all ports on the
switch.
config: Lists a subset of configuration data for all ports on the
switch; that is, for each port, the display shows whether the port
is enabled, the operating mode, and whether it is configured
for flow control.
< port-list >: Shows a summary of network traffic handled by the
specified ports.
| Intrusion
| Alert Enabled Status Mode
| No Yes
| No Yes
| No Yes
| No Yes
| No Yes
| No Yes
Viewing Port Status and Configuring Port Parameters
page 10-19
page 10-19
MDI
Mode
Up 100FDx MDI
Down 10FDx MDIX
Down 10FDx MDI
Down 10FDx MDIX
Down 10FDx MDIX
Down 10FDx MDIX
Port Status and Configuration
Flow Bcast
Ctrl Limit
off 0
off 0
off 0
off 0
off 0
off 0
10-9